Loading...
 

DinaSys

Forum List Topic List

[ prev topic | next topic ]  

DTC v3 - Set

Posted by g sweeney on 2022-01-22 20:34

Hello, i am new to this site and i have just purchased a new Turntable along with the DTS 100 control unit and the DTC v3 - Set .
I cannot seem to find access to the appropriate installation manual for these components.IN ENGLISH
I have downloaded some information from PiCommIT but the circuit boards are different than mine

Also when i tried to access configuration software it gave me the page as shown below

Any Ideas ?

Regards

Reads: 0
Link
Posted by g sweeney on 2022-01-22 20:36
Following image
Link

Posted by FvanGulik on 2022-12-06 08:57

Ik heb de draaischijfcontroller (DTCv3) en sensorplaat (DTS) geïnstalleerd.
In een eerdere poging om de Fleischmann 6052 draaischijf aan te sturen heb ik bij de motor onder de brug de spoelen en het relais verwijderd. Kan ik nu de motor gewoon op de controller aansluiten (positie 1 geel en 3 rood) zonder relais (positie 2 grijs)?

Groet,
Fred van Gulik

Link

 
Dutch (Nederlands, nl)English British (British English, en-uk)German (Deutsch, de)